Sandwich Panel Roll Forming Device, EPS Sandwich Panel Line, Mineral Wool Sandwich Panel line, Sandwich Panel Roll Forming Line

sandwich panel machine

Sandwich panel creation line is specifically designed for producing insulation composite board. With stepless pace regulation method, it is able to make corrugated composite panel efficiently at one particular time. Sandwich panel roll forming machine has been an indispensable device in fabricating roof panels and wall panels in plants and warehouses, amid other structures.

Features

one. The motor power of the sandwich panel roll forming line is 4kw, and the generation pace reaches 6m/min. With the stepless velocity regulation system, the effectiveness of the roll forming line is optional in -6m/min.

2. When creating EPS sandwich panel, the velocity is typically controlled at two-6 m/min. It will be marginally decrease for producing rock wool board (depends on true wants)

3. The composite panel production line is equipped with K-9 glue metering pump, showcasing low rotating pace and substantial precision. The glue is fed at a rate of .one-2. kg/min. It is managed by frequency converter.

4. The thickness of the composite panel the roll forming device can produce is diverse from 50mm to 250mm. By modifying the higher and reduce rack, and the distance among the cutter holder and the material feeding rack, we can get sandwich boards with various thickness and technical specs.

five. Overall installed capability: 34KW whole excess weight (including add-ons): seventeen.5t.

6. Dimension of the panel roll forming machine: 12500 (16000 for rock wool boards) X2200X2800 the roll previous for five kind EPS sandwich panel adopts 23 rubber shafts and 160X80 square tubes with thickness of 6mm the roll former for seven variety composite rock wool panel employs 45 rubber shafts, and higher and lower independent glue supply. It is equipped with 1.7m rock wool panel conveyor belt, with the diameter of the push shaft to be 50mm length of the device frame is up to 9m the roll former is welded with 180X80 sq. tubes which thickness is 8mm.

Requirements for Factories:

The factories exactly where our EPS sandwich panel generation line are utilized can be either flatroof or sloped-roof variety. The peak of the cornice must be more substantial than 5m, and the powerful width should be at the very least 45m. The floor of the factory ought to be flat and concrete. For basis of the roll forming line, it is necessary to be to be 380V, and the whole set up electricity is 34kw. It is needed for the manufacturing facility to be outfitted with .four-.6MPa compressed air offer and illumination products. The roll forming device shares the identical energy provide with the auxiliary units. The fluctuation of voltage ought to be no much more than 10%, or it might lead to an irregular operating of the system.

Leave a Reply

Your email address will not be published. Required fields are marked *