Sandwich Panel Roll Forming Equipment, EPS Sandwich Panel Line, Mineral Wool Sandwich Panel line, Sandwich Panel Roll Forming Line

sandwich panel line

Sandwich panel manufacturing line is especially designed for making insulation composite board. With stepless velocity regulation method, it is ready to produce corrugated composite panel successfully at 1 time. Sandwich panel roll forming device has been an indispensable device in fabricating roof panels and wall panels in crops and warehouses, between other structures.

Attributes

1. The motor power of the sandwich panel roll forming line is 4kw, and the production velocity reaches 6m/min. With the stepless pace regulation technique, the performance of the roll forming line is optional within -6m/min.

2. When creating EPS sandwich panel, the pace is normally controlled at 2-6 m/min. It will be slightly lower for generating rock wool board (is dependent on genuine demands)

three. The composite panel generation line is equipped with K-nine glue metering pump, that includes low rotating speed and higher accuracy. The glue is fed at a rate of .1-two. kg/min. It is controlled by frequency converter.

four. The thickness of the composite panel the roll forming device can create is varied from 50mm to 250mm. By modifying the upper and lower rack, and the distance in between the cutter holder and the content feeding rack, we can get sandwich boards with different thickness and specifications.

5. Complete mounted potential: 34KW total fat (including accessories): seventeen.5t.

6. Dimension of the panel roll forming device: 12500 (16000 for rock wool boards) X2200X2800 the roll previous for 5 type EPS sandwich panel adopts 23 rubber shafts and 160X80 sq. tubes with thickness of 6mm the roll previous for 7 sort composite rock wool panel employs 45 rubber shafts, and upper and reduced unbiased glue source. It is outfitted with one.7m rock wool panel conveyor belt, with the diameter of the travel shaft to be 50mm length of the machine frame is up to 9m the roll former is welded with 180X80 square tubes which thickness is 8mm.

Needs for Factories:

The factories exactly where our EPS sandwich panel manufacturing line are utilized can be possibly flatroof or sloped-roof type. The peak of the cornice should be greater than 5m, and the powerful width must be at minimum 45m. The flooring of the manufacturing facility must be flat and concrete. For basis of the roll forming line, it is essential to be to be 380V, and the overall put in energy is 34kw. It is necessary for the manufacturing facility to be outfitted with .4-.6MPa compressed air source and illumination devices. The roll forming machine shares the identical electrical power supply with the auxiliary units. The fluctuation of voltage must be no a lot more than 10%, or it might guide to an abnormal running of the technique.

Leave a Reply

Your email address will not be published. Required fields are marked *